Now that we know the mass of our ship, it's finally time to determine its propulsion. Each type and size of engine is rated to have a specific thrust and fuel capacity. Your ship's hull size determines the maximum number of engines it can support. You don't have to have to fill all your engine slots if that number of engines is not needed to achieve the performance you desire. And regardless of hull size and engine type, the maximum acceleration of any ship is 6g.
|
Hull Size |
Max Engines |
|
1 |
1 |
|
2-4 |
2 |
|
5-8 |
4 |
|
9-12 |
6 |
|
12+ |
8 |
Engine thrust is given as an arbitrary thrust
rating that has been scaled to work with the mass of the ship as
given in tons. To determine the maximum acceleration of your ship,
add up the thrust ratings of all your engines and divide that by the
total mass of your ship in tons. The resulting number is the maximum
acceleration of your ship in multiples of one standard gravity (10
m/s/s). Round all fractions down to the nearest tenth of a g. (Add
in a ½ A engine for fighters/shuttles)
These engines use a high efficiency chemical fuel that burns and is expelled out the engine nozzle to provide thrust. These engines are relatively cheap and easy to produce. While very powerful, because of the large volume of fuel needed, these engines have limited capability in regards to how long the engines can operate on a single fuel load. These engines are typically used for ground-to-space shuttles and system ships.
Ion engines work by ionizing hydrogen and accelerating the resulting protons and electrons to high velocity and expelling them out the back of the engine to provide thrust. Each engine contains a small nuclear reactor to provide the power needed to ionize the hydrogen and accelerate the particles to the relativistic speeds needed to generate thrust. This reactor uses the same atomic fuel pellet as an atomic engine but only needs to be replaced once every 10 years. The initial fuel pellet is included in the cost of the engine.
While not as powerful as chemical or atomic engines, Ion engine fuel is relatively cheap and if a ship is properly equipped, can be harvested from any gas giant for free.
Because of the nature of the engine, ships with ion engines cannot land or take off from planets.
An Atomic engine is a supercharged version of the chemical engine and uses the same fuel. The engine works by generating a quantum field that temporarily increases the momentum of particles by a factor of hundreds. These temporarily super-massive particle are ejected out of the back of the engine to generate the thrust for the ship. Because each particle is effectively much more massive, less fuel is needed to achieve the same thrust and instead of a single fuel load lasting for only few minutes of thrust, it can last for days and allow the ship to accelerate to Void jump speeds.
However, generating this field requires a huge amount of energy (which is transferred to the particles) during operation. To provide this power, each engine contains its own nuclear reactor, similar in design to the reactor in the ion engine. However, the large power requirement of the atomic engine means that it consumes one atomic fuel pellet after only 10,000 minutes of full thrust operations (about 8.5 days) instead of the 10 year life span for the atomic fuel pellet in an ion engine.
In addition, atomic engines require an overhaul every few jumps, again depending on the size of the engines. This overhaul is necessary to make sure that the quantum field generators are properly aligned and positioned to only affect the fuel and not the body of the engine itself. The number of trips that a ship can go between overhauls depends on the size of the engine and is give in the table with the fuel costs below.
The following table gives the cost and thrust values for each of the different types and sizes of engines. Determine the number, size, and type of engines your ship will use and then record the engines chosen for your ship.
|
|
Class A |
Class B |
Class C |
|||||
|
Engine Type |
Thrust |
Cost |
Thrust |
Cost |
Thrust |
Cost |
||
|
Chemical |
6,250 |
50,000 |
20,000 |
175,000 |
80,000 |
770,000 |
||
|
Ion |
3,000 |
100,000 |
10,000 |
400,000 |
40,000 |
2,000,000 |
||
|
Atomic |
6,250 |
250,000 |
20,000 |
1,100,000 |
80,000 |
6,000,000 |
||
Next you need to provide fuel for your engines and how much acceleration each fuel load will provide for your ship. Each engine uses different types of fuel and has different storage capabilities and requirements.
Each fuel load allows a chemical engine to operate at maximum thrust for 60 minutes. This is typically enough to allow the ship to make one round trip between the ground and orbit or limited acceleration and maneuvering in space. Each engine can only hold a single fuel load and must be refueled after each load is expended. The cost of a fuel load depends on the size of the engine and is given in the following table.
|
Engine Class |
Cost of a fuel load |
|
Class A |
300 cr |
|
Class B |
1000 cr |
|
Class C |
4200 cr |
Although not as powerful as chemical or atomic engines, these engines are reliable and can hold more fuel. While they can technically run off any material, the fuel of choice is hydrogen. Using any other fuel source decreases the thrust provided by the engines by a factor of two. Each engine can hold 10,000 fuel units and each unit provides 10 minutes of operation at maximum thrust (A fully fueled ion engine can operate continuously for over 80 days without refueling). A fuel unit costs 5, 17, or 70 cr per unit for Class A, B, or C engines respectively.
Once every 10 years, the atomic fuel pellet in the ion engine’s reactor needs to be replaced, the cost for this fuel pellet is the same as that for a similarly sized atomic engine.
Like the other engines, Atomic engines store all their fuel internally. The fuel for these engines consists of two parts. The first is a load of fuel like the chemical rockets, the second consists an atomic fuel pellet (typically uranium) to power the reactor. The amount of fuel that can be stored depends on the size of the engine and is given in the table below.
Each atomic fuel pellet and load of chemical fuel provides enough fuel for 10,000 minutes (about 8.3 days) of operation at maximum thrust. The cost of a fuel pellet depends on the size of the engine, given in the table below. The cost of the chemical fuel is identical to that of the chemical engines of the same size.
Consult the table below to determine the number of fuel loads & pellets held and time between each overhaul for each engine size.
|
Engine Class |
Trips between overhauls |
Maximum Fuel Pellets loaded |
Cost per pellet (cr) |
|
Class A |
1 |
3 |
10,000 |
|
Class B |
3 |
6 |
32,000 |
|
Class C |
10 |
12 |
Acceleration is measured in ADF One ADF is defined as 10 minutes of acceleration at 1g.
If you want to keep it simple, you can simply assume the following:
a load of fuel in a chemical rocket provides just enough thrust to make one round trip between the ground and orbit around a planet or can provide a total of 8 ADF in space.
Ion engines use one fuel unit per engine per ADF and a total of 1000 fuel units per engine for a single interstellar jump
Atomic engines use one chemical fuel load and one atomic fuel pellet for a single interstellar jump or the same fuel provides enough thrust for a total of 1000 ADF if operating solely in-system.
If you want to be a bit more exact and track the exact fuel usage you can do the following to computer the total number of ADF that a load of fuel will provide for your ship depending on the type of engine you have.
Chemical Engines – Take the maximum acceleration you calculated for the ship earlier and multiply it by 6. This is the total number of ADF your ship gets from using one load of fuel in each engine.
Ion Engines – The maximum acceleration calculated above is the number of ADF provided by expending a single ion fuel unit in each engine.
Atomic Engines – Take the maximum acceleration calculated earlier and multiply by 1000. This is the total ADF provided by using one unit of chemical fuel and one atomic fuel pellet in each of your engines.
Chemical Engine
Fully loaded a Digger Shuttle (HS 2) has one Class A chemical engine and a maximum acceleration of 4.7g. Since it has chemical engines, the total ADF provided by the single load of fuel in its engine is 4.7 x 6 = 28.2 or 28 ADF.
Ion Engine
A small (HS 7) freighter is equipped with four Class B ion engines. Fully loaded, its maximum acceleration is 1.1g. Thus by using up one fuel unit in each of it's four engines, it has 1.1 ADF available. If each engine carries it's maximum fuel load (10,000 units each), the total ADF available to the ship is 11,000 ADF. Since each interstellar jump typically takes 1000 ADF to complete, the ship can make 11 trips without refueling if it needed to.
Atomic Engine
The newly designed Swift class assault scout has a total mass of 2470.83 tons and two Class A atomic engines for a total thrust of 12500. This gives a maximum acceleration of 5.059g which rounds to 5.0. The total ADF available to the assault scout from one load of fuel in each engine is therefore 5x1000 = 5000 ADF. After expending this much thrust, the assault scout will have used two loads of chemical fuel and two atomic fuel pellets, one in each engine.